Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
afm [2018/08/01 14:00]
heather [Trouble shooting]
afm [2018/08/01 14:00] (current)
heather [Trouble shooting]
Line 165: Line 165:
   * If you're imaging a clean/flat area but still see small random streaks that seem to alternate every other scan line make sure the Isolation table display says "​Isolation Enabled."​ If you see "​Isolation Disabled",​ press the capital E on the panel to enable isolation.   * If you're imaging a clean/flat area but still see small random streaks that seem to alternate every other scan line make sure the Isolation table display says "​Isolation Enabled."​ If you see "​Isolation Disabled",​ press the capital E on the panel to enable isolation.
  
-If you see an amplitude and phase image that look reasonable, but the height and z-sensor have no texture (like imaging air would look) be sure that the computer doesn'​t need to update. In the past, a pending windows update has caused this issue.+**If you see an amplitude and phase image that look reasonable, but the height and z-sensor have no texture (like imaging air would look) be sure that the computer doesn'​t need to update. In the past, a pending windows update has caused this issue.**
  
 ===== Sample preparation ===== ===== Sample preparation =====

QR Code
QR Code afm (generated for current page)