This shows you the differences between two versions of the page.

Link to this comparison view

make_and_break [2011/05/26 15:55]
ethanminot created
make_and_break [2011/05/26 15:59] (current)
Line 2: Line 2:
 {{:​make_and_break_circuit.png?​1000|}} {{:​make_and_break_circuit.png?​1000|}}
 +The three steps shown above correspond to:
 +  -Measuring the CNT device
 +  -Making a connection to ground, before breaking the connection to measurement equipment.
 +  -The CNT device is now safely grounded so that the measuring equipment can be disconnected.
 +This type of make and break switch is often used when attaching measurement equipment to a wire-bonded nanoscale device. The three steps can be carried out in reverse order.

QR Code
QR Code make_and_break (generated for current page)